Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AdamSFX

Pages: [1]
1
Chronos User Discussion / Re: Is Krontech still in business?
« on: September 08, 2020, 07:58:50 PM »
It would certainly be good to get an official update or comment from someone at Krontech on this and other threads in the forum  :-\

2
Chronos User Discussion / Re: Updating 2.1 form 0.4.0 to 0.5.*
« on: September 02, 2020, 10:32:30 PM »
Why not flash the new firmware directly to the Micro SD card using an external computer?  That's how upgraded my 1.4
Use Method 2 of the directions posted here: https://www.krontech.ca/chronos-2-1-resources/

3
Chronos User Discussion / 3D Printable battery puller
« on: August 30, 2020, 10:17:06 PM »
I find the battery is quite awkward to remove from my camera so I made a little handle which slides onto the lugs at the bottom to pull it out, it works a treat.

If you have a 3D printer and would like one, the .stl file is attached, it is also downloadable at this link: https://1drv.ms/u/s!AhJ3lcoQ5n1nhfxf-G5qFuhm8JP-xg?e=49tRFm

 ;D

4
I'm still unable to get this working, I have done multiple resets and restarts but it stubbornly refuses to end trigger.
With all the same settings except switched to toggle rather than end trigger, it works fine.
It's very frustrating.

5
I feel like I have tried all the combinations (that's how I found it worked with 'toggle mode' with all the same settings but 'end trigger' didn't work) I tried with the slider set to all different positions, tried setting it locally and over Ethernet, tried 1mA and 20mA (and both), just can't get it working, restarted multiple times, really tried everything I can think of... 

The fact that the trigger works in toggle mode and that I can see the IO1 change from Hi to Lo on the settings page (and that it worked with earlier firmware) makes me think it's more likely be software issue and not hardware - but then it's weird that nobody else seems to be experiencing the same thing....

6
Quote
Didnt work on the first try, but eventually it started working with those settings.

Thanks for testing this, did you change anything between when it wasn't working and when it did?

7
I have a puzzling problem with my camera where the remote end trigger isn't working.

I have set the I/O properties as follows:

IO1: Record End Trigger, Debounce is selected, Invert is selected, 20mA Pullup is selected, Threshold is set to 2.5

When I press the button on the trigger, I can see IO1 go from 'Hi' to 'Lo' as expected - but nothing happens....

If I set the option to 'Toggle', it seems to work fine but I need the end trigger function.

Is there a setting I am missing somewhere?  Has anyone else experienced this? It was working fine before the update to 0.5.0, I have now updated to 0.5.1 and it's still the same

Pages: [1]