Chronos > Chronos User Discussion
please help if you know how to make a trigger cable
AIAS:
Hello everyone
I don't really know how this work, but I found in the following post that they just bring a BNC cable and switch button and it worked.
Reply #3: http://forum.krontech.ca/index.php?topic=475.0
http://forum.krontech.ca/index.php?topic=77.msg574#msg574
http://forum.krontech.ca/index.php?topic=56.msg697#msg697
I think there is smth missed but don't laugh, I bought BNC cable, BNC connector, two small wires and attached to one end of the BNC cable and connect them together as a normally open push button. I was 100% sure it won't work because there is no way that any signal will be generated... off course it didn't work ;D ;D ;D
could instruct me on how to make it.
Thank you!
PointyHairedBoss:
You don't need a signal - the trigger will work with a simple open/close switch. And you don't need BNC cable, any 2 conductor wire will work. The BNC to 2-wire connectors I found on Amazon makes things easy.
You can see my home made trigger switches here:
http://forum.krontech.ca/index.php?topic=475.msg2569#msg2569
skronstein:
What's your configuration in Trigger/IO Settings? To use the BNC as a trigger, you should have one of the pullups enabled for IO 1, and the trigger should be set to Record End Trigger.
AIAS:
I tried it here very quickly
I connect the green and yellow wires together instead of a switch for now
still, I couldn't make work.
BiduleOhm:
One wire should be on the center conductor and the other on the outside braided shield. On your image they are both on the center conductor.
Navigation
[0] Message Index
[#] Next page
Go to full version