Chronos > Software Dev

Python based simple camera interface

<< < (2/3) > >>

SergeyKashin:
For example, I will have 3 cameras and I need to launch them through the web interface at the same time, in 3 different tabs I can not do this, and through different triggers it is inconvenient

NiNeff:

--- Quote from: SergeyKashin on March 31, 2020, 04:52:55 PM ---For example, I will have 3 cameras and I need to launch them through the web interface at the same time, in 3 different tabs I can not do this, and through different triggers it is inconvenient

--- End quote ---
trigger only one and pass the signal throug triggering the others over the bnc port.

JeffNickel:
So I'll need to update my 1.04 firmware to Version 0.4.0 first.
Then connect via USB (after installing the WIN 7 USB driver.
Open a browser and input the cameras IP address,
Now have control of the camera through the gui.

To view a live image stream use VLC player and select the camera as the streaming source.

                  Question: Will the HDMI port still give the live image?

Thank you, this is awesome.

foobar:

--- Quote from: JeffNickel on April 01, 2020, 09:04:52 AM ---Question: Will the HDMI port still give the live image?
--- End quote ---

Yes, the HDMI port will continue to give you the live video from the image sensor while either the web control page, or the RTSP stream are active.

JeffNickel:
Updated to 0.4.0, switched to new interface now how do I switch back to old interface?

Navigation

[0] Message Index

[#] Next page

[*] Previous page