1
Chronos User Discussion / Re: MFT Mount for Chronos 2.1 --- Resin Print with metal Mount!
« on: February 12, 2021, 09:12:52 AM »
ok, good news, yes I managed to remove the steel CS mount, thanks to your advice
I have a speedbooster x0.64 MFT to Nikon
Yes I will be very careful, I can set the speed, I will go gradually.
For the moment I succeeded in obtaining a phase of linear acceleration with no load on 4 cm, then 20 cm at 4 m / s constant, then 4 cm of decelleration.
Don't worry, I wouldn't blame you if it breaks in 3D printing: D
I would love to have a mini CNC Mill for cutting aluminum but I have not found a suitable machine around 500-600 euros.
I have a speedbooster x0.64 MFT to Nikon
Yes I will be very careful, I can set the speed, I will go gradually.
For the moment I succeeded in obtaining a phase of linear acceleration with no load on 4 cm, then 20 cm at 4 m / s constant, then 4 cm of decelleration.
Don't worry, I wouldn't blame you if it breaks in 3D printing: D
I would love to have a mini CNC Mill for cutting aluminum but I have not found a suitable machine around 500-600 euros.