I got an "attachment not writable" when I tried to upload a word doc. See bottom of message. This seems to look like it works (recording status goes high while I hold down the button, the light goes on, the UI says "recording", but images are only intermittently captured and they don't seem to mimic the gating of the trigger).
That being said I started digging in to the API calls and there is an API call "ioMappingGate" which is not apparently exposed on the GUI. If I send that I get a valid response, but I can't set it. Perhaps this is defined in the background by the "gated burst" mode? (but the source is set to "none").
Thanks!
IO1: record end trigger, debounce: false, invert: false, pull-up:20 mA
Start recording: IO1, debounce: true, invert: true
Stop recording: delay block, debounce: true, invert: true
delay: IO1, debounce: false, invert: true, time: 0.01
IO1 out: always high, debounce: false, invert: false, drive: 20 mA
Trigger: IO1, debounce: false, invert: false BUT changing this doesn't "stick" (and in fact if I try to update the trigger from the API, that doesn't stick either)
PS I am running 0.7.0 release version. we have another camera with 0.7.1 so I am going to go check that.