KronTalk
Chronos => Chronos User Discussion => Topic started by: jasonfish on September 14, 2017, 06:39:27 PM
-
I tried today to shoot 1280x1024 at 1,000fps and couldn't get the setting to stick. No matter what I typed into the fps box, the main screen would always revert to 1.5kfps.
What am I missing?
-
Did you press enter after setting your frame rate?
You need to enter the desired frame rate, press enter, close the keyboard, then press OK.
-
i was having trouble with this too, going to try the enter
-
Did you press enter after setting your frame rate?
oops. ;)
-
Haven't tried it yet, I'm sure it works. But I've been thinking about it more.
Generally, shouldn't a value be written once the field's focus is lost? Or at the very least, shouldn't all currently displayed values be written upon OK press?
-
worked well with the enter, shot some 500 fps and 800fps today at the surf contest to get the whole wave into one trigger
-
I.. didn't even think to try that.. I was hoping to use lower than full sensor bandwidth to give long record times to ethernet/esata.. But I didn't even think to try it just writing to main memory..
On my 4s camera, 800x600, at 1000fps.. I get 11.4 seconds of record time. Brilliant!
This needs to be in the manual!