My camera arrived today, only had 20 minutes to play with it at lunch but here's my first set of feedback that is all software related so posting in this forum. Can't wait for you to open up the OS for others to tinker with, i'd love to have a play with the UI. Is that a micro SD card I spy in the bottom of the camera? Is that where the OS is hosted? Will firmware updates be done via USB or putting this card into a PC?
- I think the UI should be on the left edge of the screen. When holding the camera your thumb naturally hooks around the dial and a few times it brushed the screen and triggered one of the buttons. If the menu was on the left then it would fix that and place the menu in a nicer location to operate with the left hand when holding the camera
- The option to do the black calibration should be behind a confirmation popup that could also remind users to cover the lens, given it takes a while to process it's frustrating when you hit it by mistake then have to wait for it to finish then perform it again as the lens was more than likely not covered when it was accidentally triggered. Maybe B/W cal should be in a sub menu?
- A way to manually adjust white balance would be nice, my bad for playing with it in lower than ideal lighting but it was hard to get it to calibrate "not enough light" (or similar) error message
- The zebra exposure is perfect, the focus is confusing. It'd be super helpful to have the option to punch in (magnify the center of the sensor) to fine tune the focus