Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Willa

Pages: [1]
1
Software Dev / Re: API bugs
« on: May 11, 2022, 08:02:44 AM »
Quote
Even some of the common resolutions listed in the camera's datasheet exhibit these issues. Something is happening when I set it on the camera that is not happening when I set it via the API.
Same issue here, and I had the same thoughts... When you set the resolution in the camera, something additional is happening (looks like a small reset or so). But it doesn't happen when you set the resolution via API, resulting in unexpected behaviour.

Quote
During the filesave operation, the playback position starts at a seemingly random value (I've seen it at 100, up around 1200, etc), jumps back to 0, then goes all the way to the end like it should, but then goes back to a different random value before I receive the SSE that the camera state has switched off of "filesave".

How did you solve this...?

2
Chronos User Discussion / Re: USB otg Ethernet support
« on: April 25, 2022, 01:53:58 AM »
Now I bought a brand new Chronos 1.4 camera, and this still is not working on two computers and with 2 different cables (that are known to work). When the cam is plugged in, I get a short message in windows that "RNDIS..." is installed. And a com port is discovered. In the device manager, there is nothing with "RNDIS", but at least a new com port is found. There is also no "unknown device" appearing.  I also disabled the wind defender firewall with no luck. What can I do???

3
Chronos User Discussion / Re: USB otg Ethernet support
« on: January 31, 2022, 12:27:15 AM »
So there is noone that can help here? What a pity.

4
Chronos User Discussion / USB otg Ethernet support
« on: January 26, 2022, 10:44:43 PM »
Hi there,
We are currently evaluating the Chronos 1.4 for Particle Image Velocimetry. I would like to include the camera into an existing MATLAB GUI. Therefore, I am trying to connect to it via USB and the static IP address given in the manual. However, the camera is not found. The IP address can't be pinged, and the Webinterface + MATLAB example scripts can't access the camera. Do I need to do more than what's described on the manual to make USB otg work? I have the latest firmware (0.7.1) and windows 11. I am using an USB cable that is known to work, and tried two different computers.
The camera serial nr. is 00320.
Thanks for your help!
William

Pages: [1]