1
Software Dev / Camera powers off after update to 0.3.2
« on: July 24, 2019, 12:43:15 AM »
Hi all
I updated my camera from v0.3.1 to the latest and greatest beta yesterday and all appeared well. I did the calibration backup before updating as well. Once done I had a little play including saving to an SSD card connected via esatap and several reboots.
Later in the evening after it had been off for a while I decided to try something else but the camera wouldn't boot or stay on. Sometimes it wouldn't get past a black screen (the splash screen always shows) and eventually just turns off. Other times it will get to the main UI screen and then just shut down. There is time to press one button to which it responds but then it powers off. There was one instance when it got to the main screen but showed lots of multicoloured snow, I just rebooted when it did this and now it won't start at all
Please help me get it either working or reverted back to an earlier firmware
Thanks
Ian
Update:
OK, got some coffee in me and I disconnected the power and battery for a short while and it will now boot and stay up. On boot though it takes two attempts with the first being reset by the watchdog if I don't miss my guess. It has done this several times consistently now.
I also notice there is a lot of screen speckling when the focus assist is active. This is not really a problem, just an observation.
More playing soon
Thanks
I updated my camera from v0.3.1 to the latest and greatest beta yesterday and all appeared well. I did the calibration backup before updating as well. Once done I had a little play including saving to an SSD card connected via esatap and several reboots.
Later in the evening after it had been off for a while I decided to try something else but the camera wouldn't boot or stay on. Sometimes it wouldn't get past a black screen (the splash screen always shows) and eventually just turns off. Other times it will get to the main UI screen and then just shut down. There is time to press one button to which it responds but then it powers off. There was one instance when it got to the main screen but showed lots of multicoloured snow, I just rebooted when it did this and now it won't start at all
Please help me get it either working or reverted back to an earlier firmware
Thanks
Ian
Update:
OK, got some coffee in me and I disconnected the power and battery for a short while and it will now boot and stay up. On boot though it takes two attempts with the first being reset by the watchdog if I don't miss my guess. It has done this several times consistently now.
I also notice there is a lot of screen speckling when the focus assist is active. This is not really a problem, just an observation.
More playing soon
Thanks