Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - EB

Pages: [1]
1
Software Dev / Re: Chronos V0.7.0 Full Release
« on: December 29, 2022, 04:14:56 PM »
Well, turns out the SD card issue was with the card itself (a Kingston SDC10G2/16GB microHDHC class 10 UHS-I card). This Kingston card did verify properly with Etcher when writing the CD Card, so the fault must be subtle. When I tried a 32BG Samsung Pro Endurance card (also UHS-I), the 0.7.2 boot image worked.

I was running 0.5.1 off an 8GB SanDisk UHS-I card (shipped with the camera?), so I guess you need to pay attention to the quality of the card.

I still had issues with the network upgrade, though, as described above.

2
Software Dev / Re: Chronos V0.7.0 Full Release
« on: December 29, 2022, 01:53:12 PM »
I'm not able to perform this update to 0.7.1 on my 1.4 colour camera. I am currently running 0.5.1.

If I try the internet upgrade, I get an apt error saying that the 10 update packages found (all with chronos in their name) cannot be authenticated and that "-y was used without --force-yes". The update fails. After the subsequent automatic reboot, I'm still on 0.5.1. Perhaps there is an error in the update script?

If I try the SD card update method, when I insert the new SD card (which was successfully loaded with the new boot image using Etcher), the camera screen just stays blank and the fan activates for about 1sec every minute or so, but there is no visible progress. Inserting the old SD card restores 0.5.1

Has anyone seem either of these issues? How can I upgrade the firmware on the camera?

Pages: [1]