Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jay

Pages: [1]
1
Software Dev / Re: Camera powers off after update to 0.3.2
« on: November 01, 2019, 10:32:35 AM »
I had the same issue today. Didn't used the cam for a week. Was constantly on power connection.
When I tried to start the cam, I just had a black screen. Tried several times, same result. When I checked the forum and found this thread, removing the battery for a few seconds while disconnected from the power, made the cam boot normal again. I do not have any of the power down issues, just to mention that, the cam just refused to boot.

Software version 0.3.2

2
Software Dev / Re: Software update V0.2
« on: November 10, 2017, 01:06:14 PM »
Wups ^^ now I feel stupid ;)

Worked very easy with the stick. Thanks for the help!

3
Software Dev / Re: Software update V0.2
« on: November 09, 2017, 10:51:56 PM »
I have a little problem. Copied the software to the Fat32 SD.
Started the cam and went into Util to press Backup. -> Gives an error, SD not present.
When I press the trigger and make a short clip, I can save to the SD card without a problem. Just Backup Calibration Data tells me there is no card..
/media/NAME is different in the Recording settings and the error message, so I understand the error msg.. just dont understand why it gives 2 different paths, only has one card slot.
error: no device is mounted to /media/sda1
I save in Play/Settings to: /media/mmcblk1p1 (SD card Partition 1) and that works fine every time

Anybody had that before?

regards
Jay

4
Chronos User Discussion / Re: SDXC Card
« on: November 03, 2017, 05:17:19 AM »
I use this software to format to Fat32:
https://fat32-format.en.softonic.com/download

and don't use "quick" for the first run. Let it format the card and not just the table of content.

Pages: [1]