Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - JeffNickel

Pages: [1]
1
Software Dev / I/O settings not updated from camera via Network control
« on: November 04, 2022, 10:42:10 AM »
While under Web control there is not provision to change the "Record Length".

Also, the I/O Settings controls do not reflect the current state of the camera so I cannot be sure that the changes have taken place.  The trigger Hi/Lo indicator works in real time but not the setting options.

I tested this and can see after refreshing the Settings screen on the camera that my selections get updated but I have no idea without opening this screen.  I use my cameras remotely under water in Salty housings so confirming these settings would mean bringing the camera to the surface to check.

Are there plans to include real-time monitoring of I/O settings and changing the Record Length via Web control in the future?
Jeff

2
Chronos User Discussion / Loosing settings when power lost.
« on: November 03, 2022, 05:24:45 PM »
Hello,
If the battery dies do the settings in the camera get reset?  If I power down the camera it saves the settings. But are they saved if the battery gets to low or dies?

Asking for a friend..

Jeff

3
I have two 2.1s and a 1.4.  I am using the 2.1s under water in Salty enclosures which I cannot access during the tests after calibration has been done.
I lost power to one under water camera and the settings got reset (I am recording 5 second videos at 200fps).
I am not able to find where I can reset the record length to 5 seconds via the Web interface.  Is this possible?

Thanks,
Jeff

4
Chronos User Discussion / What is sample rate of TRIG2 INPUT?
« on: August 15, 2022, 03:41:54 PM »
Hello,
Trying to sync 3 Chronos cameras but if I use the Frame Sync Output to trigger the camera the live image gets scrambled and freezes the camera.

I therefore have to trigger the cameras in parallel and want to know the sample rate of the Trig2 input ports to know if the frames will not start close enough together as I will be using the three videos to calculate velocities.

Regards,
Jeff

5
Chronos User Discussion / Wide angle lens for 2.1
« on: November 23, 2021, 02:46:25 PM »
Can anyone recommend a CS lens with viewing angle min 35 degrees that works with my 2.1 without vignetting?

6
Software Dev / Python based simple camera interface
« on: March 31, 2020, 10:38:29 AM »
For the non-programmers among us has anyone created a simple python gui for my laptop that can control the cameras basic functions (Start, stop, save, view live, etc?  I understand that the necessary files are available however I do not have the programming wisdom to create something on my own.  Perhaps if you have created such a beast, however beta, you might share it with the unwashed?

Pages: [1]