31
Chronos User Discussion / Forum not secure
« on: December 01, 2021, 08:00:47 AM »
Is anyone else getting forum not secure when they try to logon ? I think maybe the certificate needs updating.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
32
Chronos User Discussion / Re: Dealing with constantly-loosening EF-mount adapter
« on: July 03, 2021, 06:01:11 AM »
That looks great
33
Chronos User Discussion / Re: What Lights Do You Use?
« on: February 01, 2021, 03:16:04 PM »
I have Godox VL300 300w LED Lights with Neewer Fresnel 2X Lenses if I need them. They do get quite hot but give a lot of light, they not as hot as incandescent lights though, If they re all on 100% I have to wear eye protection.
34
Chronos User Discussion / Re: Create light for high-speed shooting 1500w
« on: January 15, 2021, 09:57:56 AM »
You could maybe use a Arduino type device to control each section wired to a switching amplifier. You would need to write a small piece of code to allow 2 push switches to control the PWM on each section via its associated Pin. It would be interesting to see if a 36v stepper driver would work as you can limit the current and they pulse really fast so you would limit flicker at high frame rates. I wouldn't be testing it with a £500 LED though lol.
I have used an Arduino to control LED strips using the controller in the image attached obviously you would need something that would switch a lot more current for bigger LEDS, It did work ok I had it set to send serial signals to control the brightness from my PC.
I will see what bits I have floating around and try to experiment to see if the stepper driver will work.
I have used an Arduino to control LED strips using the controller in the image attached obviously you would need something that would switch a lot more current for bigger LEDS, It did work ok I had it set to send serial signals to control the brightness from my PC.
I will see what bits I have floating around and try to experiment to see if the stepper driver will work.
35
Chronos User Discussion / Re: Post Chronos 2.1 clips here!
« on: December 01, 2020, 12:25:52 PM »Carbide Insert Enmill, f/11 and 243°, otherwise same settings as above. Sorry for all the Dirt on the Lens btw.
That looks great !
36
Chronos User Discussion / Re: Post Chronos 2.1 clips here!
« on: November 18, 2020, 12:53:19 PM »
My first proper video from the new camera, I think its going to be a steep learning curve! I'm finding it challenging but interesting just going through lenses to see which works best for me.
https://www.youtube.com/watch?v=9av9cbsWJS0&ab_channel=Josef1
https://www.youtube.com/watch?v=9av9cbsWJS0&ab_channel=Josef1