Chronos > Software Dev
Deploying camApp from Qt Creator
Matom:
I also timed the routine without including my algorithm and in this case the cpu-time was around 2 seconds for 1000 frames, whereas the real time was still 16 seconds. Therefore, I think that there must be a delay or a set frame-rate somewhere. Maybe in the OMX files? I just can't seem to find the one that does the trick.
DDR:
--- Quote from: Michaelslimb on August 05, 2018, 03:08:02 AM ---Im running Windows 10 and using Qt Creator. I installed Qt 5.8.0.
--- End quote ---
Hi Michael, I'm afraid Windows 10 is not a supported development platform. In addition, Qt 5.8.0 will not run on the Arago linux, the operating system of the camera.
Your best bet is to install Ubuntu in a VM such as VirtualBox and modify the existing QT 4 camapp, as per these instructions.
We have a version of the camera running Debian that can compile for itself, but I do not currently have video capture working on it. That will be brought together after my colleagues return from DEF CON, and hopefully documented not long after.
Best of luck!
Navigation
[0] Message Index
[*] Previous page
Go to full version