I installed the version 0.3.1 update early today and ran some test shots to ensure everything was working. No problems. I then applied the v0.3.2 update. After letting the camera warm up for 40 minutes, I did the factory black calibration followed by another manual black calibration. When I went to start shooting, there were multiple narrow vertical bands about 1 pixel wide across the frame (example attached) that would not go away with additional black calibrations. This banding is very visible even on the LCD screen in both live and playback. Note that I have had problems with banding not going away on my camera before this update, perhaps there is an issue with my camera's sensor that is causing this?
So, I reverted back to the v0.3.1 update, which was successful. However, there are two problems that haven't gone away with several reboots:
1.) The "No Batt" indicator displays at the bottom. The camera still operates without the external power adapter plugged in, but the "no batt" indication remains instead of the normal percentage remaining.
2.) The camera will not power down using the main power button. A "hard" power down (holding the power button for 10 seconds) is the only way to turn the camera off.
Other than those two issues, the camera seems to be working normally (shooting, saving files, etc), though I have not yet put it through its paces on a normal shoot.
The attached image below is a frame after installing v0.3.2. It is nighttime here and I am on the road, so no well-lit scenes were available.
