Fitting the Micro Four Thirds Mount

[Visualtec]

I have just purchased the Kron Micro Four Thirds Mount is there anything need to watch out for when fitting it ? I also have the Aputure DEC lens regain 0.75x focal reducer, adapter EF to MFT, wireless focus. The idea is I can use my Canon EF macro lenses and control the aperture. I'm not sure if the .75 will be a problem but I will find out when its fitted I guess.

[Nikon1]

Make sure the Camera Front Surface is Clean when Mounting, also make sure to Remove the Stainless CS-Mount Ring together with The Screw and Clamping Rod when using anything like the Focal Reducer.
 Then proceed to Figure out the Correct Shims to put under it.
 Tighten The Screws firmly, but dont over torque the Screws, as that can damage and Distort the Camera Body or the Threads inside the Camera.
 Proper Torque for Fastening these Screws is about 1,4Nm if you happen to have a small Torque Driver.
 .
 Other than that, there is not much to it really, but if you want, i can shoot a Quick "How-To" Video and post that, so you can follow that in Detail.

[Visualtec]

Thanks for the offer of a video. I will have a go and if I get stuck I will take you up on the offer ! I will remove the mount ring thanks

[Visualtec]

I managed to get it fitted really pleased with it. The camera feels more solid not sure if its just in my head but I prefer the MFT mount to C mount. I have a speed booster and can fit my macro lenses now will post some results once I get everything set up,.