Hi all,
I am using the 1.4 in segmented mode with a TTL trigger signal for a project.
The camera is controlled and set via the API.
Everything also works perfectly in burst mode.
However, if I set it to segmented mode, it also works, but with 10 segments set, 11 always come out. Segments 2-10 have the correct calculated number of frames, but numbers 1 and 11 do not. Their sum gives the correct number.
The signal was checked for correctness with an oscilloscope, this is not where the error lies. After a lot of trial and error, it also turns out that the problem only occurs from cameraMaxFrames > 33990, below this number everything works as expected
Do any of you know why this problem occurs?
Thanks in advance
I am using the 1.4 in segmented mode with a TTL trigger signal for a project.
The camera is controlled and set via the API.
Everything also works perfectly in burst mode.
However, if I set it to segmented mode, it also works, but with 10 segments set, 11 always come out. Segments 2-10 have the correct calculated number of frames, but numbers 1 and 11 do not. Their sum gives the correct number.
The signal was checked for correctness with an oscilloscope, this is not where the error lies. After a lot of trial and error, it also turns out that the problem only occurs from cameraMaxFrames > 33990, below this number everything works as expected
Do any of you know why this problem occurs?
Thanks in advance
Last edited:
